Hello,

I am using FC.NET 4.3 and have a couple of questions about auto-routing arrows as I can't seem to make them behave as I would like them to.

I am drawing a simple electrical layout diagram and need the arrows to always have a vertical orientation at the start and end, so I set those properties in the RoutingOptions.  The arrowstyle is set to Cascading.  However, sometimes when I move a box up or down in the chart the start and end segments switch to horizontal.  Do I need to trap a routing event and force the orientation to what I need??  If so, which event should I trap??

Second observation/question.   When I allow the arrows to autoroute the arrow lines actually overlap (they are drawn right on top of each other).  I need to force a space between arrow lines so that the diagram is readable.  Do I do this in one of the routing events??  Or, do I just need to set some different RoutingOptions??

Thank you again,
Jeff

Hello,

It seems that was a double post; please check if the tips here will help -

http://mindfusion.org/cgi/Forum/YaBB.pl?board=fcnet_disc;action=display;num=1173...

Stoyan