(UTC)
  The MindFusion Forums › Flow Diagramming Components › Windows Forms › add control point nd change location
(Moderator: Slavcho)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic add control point nd change location (Read 1230 times)
alesdario
Junior Member
**
Offline



Posts: 71
Joined: Mar 7th, 2007
add control point nd change location
Mar 8th, 2007 at 1:51pm
Print Post  
i promise that this is the last time i ask you a question!
I've two last doubt.
First: how can i add a control point to bezier arrow?

Second: is there a method who allow me to change location of a Box after i create them?

TANKS!!
  
Back to top
 
IP Logged
 
Stoyo
God Member
*****
Offline


MindFusion support

Posts: 13230
Joined: Jul 20th, 2005
Re: add control point nd change location
Reply #1 - Mar 8th, 2007 at 2:34pm
Print Post  
Hi,

Please do not hesitate to ask questions at any time 8)

Unfortunately you cannot add a single point to the Bezier arrow. You can only add a whole segment, which is three additional points. That will also reset the control point coordinates, so you might need to save the old ControlPoints values, and restore them after adding the segment.

You can use the Move method or the BoundingRect property to change the box location.

Stoyan
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

The MindFusion Forums » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge