(UTC)
(Moderator: Slavcho)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Unable to Move Node (Read 1799 times)
muthuhamid
Junior Member
**
Offline


I love YaBB 1G - SP1!

Posts: 60
Joined: Feb 1st, 2009
Unable to Move Node
Nov 10th, 2011 at 10:13am
Print Post  
Hi Stoyo
I have some shapenodes in the diagram. Among these nodes one of the node's Height is 3. When i try to move this node using mouse, am unable to move. After i move, it comes back to its original position again. But if I change the height to greater than 6, then am able to move it.

When i create this node i did not assign any value to the HandlesStyle property as i left it to default value. Later i tried this property value with EasyMove and MoveOnly, nothing helped out.

And the events NodeModifying or NodeModified are not fired too.

I could not figure out the reason for this.
Could please help me in this regards?

Thanks and Best Regards
Muthu
  
Back to top
 
IP Logged
 
Stoyo
God Member
*****
Offline


MindFusion support

Posts: 13230
Joined: Jul 20th, 2005
Re: Unable to Move Node
Reply #1 - Nov 10th, 2011 at 10:31am
Print Post  
Hi Muthu,

It should be the same issue as here:
http://mindfusion.eu/Forum/YaBB.pl?board=fcnet_disc;action=display;num=130856441...

I hope that helps,
Stoyan
  
Back to top
 
IP Logged
 
muthuhamid
Junior Member
**
Offline


I love YaBB 1G - SP1!

Posts: 60
Joined: Feb 1st, 2009
Re: Unable to Move Node
Reply #2 - Nov 12th, 2011 at 11:18am
Print Post  
Hi Stoyo

Yes .. it is same issue got fixed now...

Thanks a lot..

Regards
Muthu
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

The MindFusion Forums » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge